top of page
Search

How to Apply Paint Protection Film in Dubai

Updated: Mar 10



For car lovers in Dubai and beyond, protecting your vehicle's paint from the harsh desert environment is crucial. One of the most effective ways to shield your car's finish is by applying paint protection film (PPF). This guide will walk you through the process of how to apply paint protection film, ensuring your car stays looking pristine for years to come.


What is Paint Protection Film?

Paint Protection Film, also known as PPF or clear bra, is a thin, transparent urethane film that is applied to a vehicle's exterior to protect it from scratches, chips, and other forms of damage. This nearly invisible layer acts as a shield against road debris, insects, and environmental contaminants.


Benefits of Paint Protection Film

  • Protects against rock chips and road debris

  • Shields paint from UV rays and oxidation

  • Preserves resale value by maintaining the car's appearance

  • Self-healing properties (in some high-quality films)

  • Virtually invisible when properly applied


Tools and Materials Needed

Before learning how to apply paint protection film, gather these essential items:

  • Paint Protection Film kit

  • Spray bottle with slip solution

  • Squeegee

  • Heat gun or hairdryer

  • Microfiber towels

  • Isopropyl alcohol

  • Clay bar

  • Car soap

  • Bucket

  • Sponge or wash mitt


Preparing Your Car for PPF Application

  1. Wash your car thoroughly using car soap and water

  2. Clay bar the surface to remove any contaminants

  3. Dry the car completely with microfiber towels

  4. Use isopropyl alcohol to remove any remaining residue


Step-by-Step Guide: How to Apply Paint Protection Film

  1. Measure and Cut the Film

    • Measure the area where you'll apply the PPF

    • Cut the film slightly larger than the measured area

  2. Prepare the Slip Solution

    • Mix water and a few drops of baby shampoo in a spray bottle

  3. Wet the Surface

    • Spray the slip solution generously on the car's surface and the adhesive side of the PPF

  4. Position the Film

    • Carefully place the PPF on the wet surface

    • Adjust its position while it's still floating on the solution

  5. Squeegee the Film

    • Starting from the center, use the squeegee to push out water and air bubbles

    • Work your way to the edges in smooth, overlapping strokes

  6. Trim Excess Film

    • Use a sharp utility knife to carefully trim any excess film along the edges

  7. Heat and Seal

    • Use a heat gun or hairdryer to activate the adhesive and seal the edges

    • Be careful not to overheat the film

  8. Final Inspection

    • Check for any remaining bubbles or imperfections

    • Use the squeegee to address any issues

Maintaining Your Paint Protection Film

To keep your PPF in top condition:

  • Wash your car regularly with pH-neutral car soap

  • Avoid automatic car washes with brushes

  • Don't wax over the PPF (unless recommended by the manufacturer)

  • Address any lifting edges promptly to prevent further peeling

Remember, proper preparation and careful application are key to achieving the best results. If you're unsure about your ability to apply PPF correctly, don't hesitate to seek professional help. Your car's appearance and value are worth the investment.

 

If you have plans to install paint protection film in Al Quoz, Contact us for more information.  

 
 
 

Recent Posts

See All

Comments


WHATSAPP
bottom of page